IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

FRU Removals and Replacements 755Ce, 755Cse, 755CV, 755CX (9545)

•  Rear Connector Door
•  Foot
•  Battery Pack
•  Diskette Drive
•  Hard Disk Drive
•  IC DRAM Card or DIMM Adapter
•  Diskette Drive Bezel
•  Keyboard Unit
•  Status Indicator
•  Standby Battery and Front IR
•  Backup Battery
•  Logic Assembly
•  Shield Assembly
•  DC/DC Card
•  DSP Card
•  Interposer Card
•  System Board Assembly
•  PCMCIA Slot Assembly
•  Processor Card
•  LCD Assembly
•  LCD Rear Cover (755CV only)
•  Lower Shield Assembly
•  Memory Card

•  An electrostatic discharge (ESD) strap must be used to establish personal grounding.

   The system board is sensitive to, and can

  be damaged by,   electrostatic discharge. Establish personal grounding  by touching a ground point with one hand before touching these units.

•  The arrows in the Removals and Replacements section show  the direction of movement to remove a FRU, or to turn a screw to release  the FRU. The arrows are marked in numeric order, in square callouts, to  show the correct sequence of removal.
•  When other FRUs must be removed before removing the failing FRU,  they are listed at the top of the page.
•  To replace a FRU, reverse the removal procedure and follow any  notes that pertain to replacement. See 'Locations' for internal  cable connections and arrangement information.
•  When replacing a FRU, use the correct screw size as shown in the  procedures.

•  Safety Notice 8
•  Safety Notice 3
•  Safety Notice 1

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.