Jumper / Switch Settings
The following tables contain the jumper/switch setting information.
(D) indicates the default setting.
| Jumper | Setting | Description |
|---|---|---|
| CMOS Reset | 2-3 1-2 (D) |
CMOS reset. Normal. |
Celeron™ - Processor Speed Switch Setting SW1 1-4
| CPU Switch Settings |
SW1-1 | SW1-2 | SW1-3 | SW1-4 |
|---|---|---|---|---|
| 300 MHz Celeron™ |
Off | On | Off | On |
| 333 MHz Celeron™ |
On | Off | Off | On |
| 366 MHz Celeron™ |
Off | Off | Off | On |
| 400 MHz Celeron™ |
ON | ON | ON | Off |
| 433 MHz Celeron™ |
Off | ON | ON | Off |
Flash Boot Block Recovery Switch SW1-5
| Flash Boot Block | SW1-5 |
|---|---|
| Normal Mode | Off (D) |
| Recovery Mode | On |
Diskette Write Access Switch SW1-6
| Diskette Access | SW1-6 |
|---|---|
| Write Enabled | Off (D) |
| Write Protected | On |
Supported (256 MB max.) Memory Configurations
Any combination of 16, 32, 64, or 128 MB DIMM sizes, are acceptable.
Start filling at DIMM socket 0.
Use 3.3 V unbuffered Non-parity DIMMs only.
See 'System board memory' for DIMM size, speed and type.
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.