 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Flash Recovery Boot Block Jumper (300/700-Series / IntelliStation)
Flash Recovery Boot Block Jumper (300/700-Series / IntelliStation)
-Attention- If an interruption occurs during the Flash/BIOS upgrade process, the BIOS
might be left in an unusable state.
The Boot Block Jumper or Switch enables you to restart the
system and recover the BIOS.
To perform a Flash/BIOS recovery using the Boot Block jumper/switch:
- Power-off the computer and remove the cover.
- Move the system board Boot Block jumper or switch to the recover position.
- Insert the upgrade diskette into the diskette drive.
- Power-on the computer. The IBM Logo will appear.
- When the Flash update Utility appears, select your country/keyboard, then press Enter.
- If the computer serial number was previously recorded, the number is displayed with an option to update it.
Press Y to update the serial number.
- Type the 7-digit serial number of the computer you are servicing, then, press Enter.
- Follow the instructions on the screen to complete the flash (BIOS/VPD) update procedure.
- When you are instructed to reboot the computer, power-off the computer and move the Boot Block jumper
or switch to the normal position.
Then, replac the cover and power-on the computer.
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a
for any BUG on this page found - Thank you.