 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
FRU Removals and Replacements (2600-310/310D/310E/310ED)
FRU Removals and Replacements
This section contains information about removals and replacements.
Before removing any FRU, power-off the computer,
unplug all power cords from electrical outlets, remove the battery pack, and then disconnect any interconnecting cables.
Then read 
Handling ESD sensitive parts
Before the computer is powered-on after FRU replacement see 
Safety 1
- Do not damage any parts. Only certified and trained personnel should
service the computer.
- The arrows in this section show the direction of movement to remove a FRU,
or to turn a screw to release the FRU. The arrows are marked in numeric order, in square callouts, to show the correct
sequence of removal.
- Any FRUs that must be removed in order to remove the failing FRU are listed at the top of the page.
- To replace a FRU, reverse the removal procedure and follow any notes that pertain to replacement. See
'Locations' for internal cable connections and arrangement information.
- When replacing a FRU, use the correct screw size, as shown in the procedure.
The battery pack contains small amounts of nickel. Do not disassemble it, throw it into fire or water, or short-circuit it.
Dispose of the battery pack as required by local ordinances or regulations.
Back to 
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.