 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Removal and Replacement (SelectaDock II - III)
Removal and Replacement
This section contains information on removals and replacements,
as well as locations.
- The arrows in the removals and replacements show
the direction of movement to remove a field replaceable unit (FRU), or
to turn a screw to release
the FRU. The arrows are marked in numeric order to
show the correct sequence of removal.
- When other FRUs must be removed before the failing FRU is removed,
they are listed at the top of the page. Go
to the removal procedure for each FRU listed, remove the FRU, and
then continue with the removal of the failing FRU.
- To replace a FRU, reverse the removal procedure and follow any
notes that pertain to replacement. See Locations for internal
cable connections and arrangement information.
In addition to the safety notices below, refer to the Hardware
Maintenance Manual for the computer you are servicing.
Before removing any FRU, power-off the SelectaDock Docking System, remove the computer
unplug all power cords from electrical outlets,
and then disconnect any interconnecting cables.
The main board, adapters, and circuit boards on the drives are
sensitive to, and can be damaged by, 
electrostatic
discharge.
You must use an electrostatic discharge (ESD)
strap to establish personal grounding.
Back to 
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.