Pentium® III processors do not require speed settings.For Pentium® III processors, you can ignore the speed settings.
Pentium® II - Processor Speed Switch Setting (SW1 1-4)
1 Battery
2 Switch SW1
3 Microprocessor Socket
4 DIMM Socket 0
5 DIMM Socket 1
6 DIMM Socket 2
7 CMOS Clear Jumper (J9)
8 Video Memory Connector
9 Display Connector
10 Mouse / Keyboard Connector
(top = Mouse / bottom = Keyboard)
11 Serial Connectors
(top = Serial port 2 / bottom = Serial port 1)
12 USB Connectors
(top = USB port 2 / bottom = USB port 1)
13 Parallel Connector
The following tables contains the switch settings.
(D) indicates the default setting.
CMOS Reset (J9)
| Jumper | Setting | Description |
|---|---|---|
| CMOS Reset | 2-3 | CMOS reset |
| Normal Work | 1-2 | Normal |
Pentium® III processors do not require speed settings.
For Pentium® III processors, you can ignore the speed settings.
Pentium® II - Processor Speed Switch Setting (SW1 1-4)
| CPU Switch Settings |
SW1 - 1 | SW1 - 2 | SW1 - 3 | SW1 - 4 |
|---|---|---|---|---|
| 233/66 MHz | Off | Off | ON | ON |
| 266/66 MHz | ON | ON | Off | ON |
| 300/66 MHz | Off | ON | Off | ON |
| 333/66 MHz | ON | Off | Off | ON |
| 350/100 MHz | Off | Off | ON | ON |
| 400/100 MHz | ON | ON | Off | ON |
| 450/100 MHz | Off | ON | Off | On |
Celeron™ - Processor Speed Switch Setting (SW1 1-4)
| CPU Switch Settings |
SW1 - 1 | SW1 - 2 | SW1 - 3 | SW1 - 4 |
|---|---|---|---|---|
| 300 MHz | Off | ON | Off | ON |
| 333 MHz | ON | Off | Off | ON |
| 366 MHz | Off | Off | Off | ON |
| 433 MHz | Off | ON | ON | Off |
ROM Operation Switch (SW1-5)
| ROM Operation | SW1-5 |
|---|---|
| ROM Recovery Mode | ON |
| Normal ROM Operation | Off (D) |
Reserved Switch (SW1-6)
| Reserved | SW1-6 |
|---|---|
| Reserved | Off (D) |
Privilege Access Password (PAP) Switch (SW1-7)
| PAP | SW1-7 |
|---|---|
| Disable | Off (D) |
| Enable | On |
Diskette Write Access Switch (SW1-8)
| Diskette Access | SW1-8 |
|---|---|
| Write Enabled | Off (D) |
| Write Disabled | On |
Supported Memory Configurations
DIMM sizes of 16MB, 32MB, 64MB, and 128MB are acceptable. Start filling
DIMM socket 0, then 1, then 2. Use 3.3V unbuffered 100MHz SDRAM Non-Registered
DIMMs only. Non-parity or ECC DIMMs are supported. Install only ECC DIMMs to
enable ECC.
See > 
'System Board Memory' for DIMM size, speed,
and type.
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.