1 CMOS Clear Jumper (J6C1)
2 Buzzer
3 Processor socket
4 Fan Connector for processor Fansink if required.
5 Reserved Jumper (EPROM protect) (J2A1)
6 DIMM socket 0
7 DIMM socket 1
8 Battery
9 Monitor connector
10 Parallel Port connector
11 Serial 1 connector
12 Serial 2 connector
13 Keyboard connector
14 Mouse connector
15 USB connectors
(top = USB1, bottom = USB2)
16 BOOT Block - Recovery Jumper (J7H1)
Jumper Settings J6C1, J7H1, J2A1
| Jumper | Setting | Description |
|---|---|---|
| CMOS Clear J6C1 |
2-3 1-2 (D) |
CMOS clear Normal |
| Boot Block Recovery J7H1 |
2-3 1-2 (D) |
Recovery Normal |
| Reserved Jumper J2A1 |
2-3 (D) 1, 2 |
Normal Reserved |
NOTE: Settings such as Diskette write enable
and Processor speed control are performed within the
Configuration/Setup Utility.
To start the Configuration/Setup Utility, see 'Setup Utility Program'.
Listed below are some of the settings in the Configuration/Setup Utility:
System Security
Advanced Setup
Supported Memory Configurations
Any combinations of 16MB, 32MB, 64MB or 128MB DIMM sizes, are acceptable.
Start filling DIMM socket 0, then 1. Use 3.3V unbuffered EDO DIMMs only.
Non-parity or ECC DIMMs are supported. Install only ECC DIMMs to enable ECC.
See > 
'System Board Memory' for DIMM size, speed,
and type.
Supported Memory Configurations
| total Memory |
Bank 0 | Bank 1 |
|---|---|---|
| 16MB | 16MB-SDRAM | 0 |
| 32MB | 32MB-SDRAM | 0 |
| 48MB | 16MB-SDRAM | 32MB-SDRAM |
| 64MB | 64MB-SDRAM | 0 |
| 64MB | 32MB-SDRAM | 32MB-SDRAM |
| 80MB | 64MB-SDRAM | 16MB-SDRAM |
| 96MB | 64MB-SDRAM | 32MB-SDRAM |
| 128MB | 64MB-SDRAM | 64MB-SDRAM |
| 128MB | 128MB-SDRAM | 0 |
| 256MB | 128MB-SDRAM | 128MB-SDRAM |
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.