Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Numeric Error Codes (3547)



Numeric Error Codes

Symptom/Error    SelectaDock Docking System
     FRUs Sequence of Actions
  
10X, 11X 1. Adapter in slot (if used)
101: Interrupt failure. 2. Riser card
102: Timer failure. 3. Main card
103: Timer interrupt failure.
104.: Protected mode failure.
105: Last 8042 command not accepted.
107: NMI test failure.
108: Timer bus test failure.
109: Low meg-chip select test.
195 1. Do the following steps.
(The computer was docked to the     a. Power-off and undock the system.
SelectaDock Docking System while     b. Power-on and shut down the system.
in hibernation mode.)     c. Power-off and dock the system.
  
1XX 1. See the Hardware Maintenance Manual
      of the computer.
      If the problem remains, go to 'Undetermined Problems'
  
2XX 1. See the Hardware Maintenance Manual.
201: Memory data error.     of the computer.
202: Memory line error 00-15. 2. Main card
203: Memory line error 16-23.
205: Memory test failure on on-board memory.
221: ROM to RAM remap error.
3XX 1. See 'External Keyboard'
  
6XX 1. Before changing any devices,
      run the diagnostic test.
      (See the 'How to Run the Diagnostics')
  2. FDD external attachment kit
  3. Diskette drive assembly
  4. Riser card
  
11XX, 12XX 1. Serial devices
  2. Communication cable
  3. Riser card
  
17XX 1. Hard disk drive
  2. Main card
      (2.5-inch ThinkPad hard disk drive)
  
24XX 1. Main card
  2. Riser card
  
860X 1. Mouse
  2. External keyboard
  3. Riser card
  
I9990301, I9990302 1. See the Hardware Maintenance Manual.
I9990305     of the computer.
  
Not shown above 1. See the Hardware Maintenance Manual
  2. See 'Undetermined Problems'.
      of the computer.


More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.