Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

How to Run the Diagnostics (3547)



How to Run the Diagnostics


Use either the TrackPoint III or the cursor move keys to interact with the tests. The Enter key works the same as selecting the OK icon to reply OK.
  1.  Press and hold the F1 key, then power-on the computer.  Hold the F1 key down until the Easy-Setup screen appears.
  2.  Select Test and press Enter.
  3.  Select a device and press Enter to run the test.
  4.  The test progress screen appears.
  5.  OK appears when the test ends without any errors.
  6.  Start the Advanced Diagnostic test by pressing Ctrl+A on the basic diagnostic menu screen.
  7.  Select Tool to install the tools.
  8.  Select a device, press the Spacebar and  install the tool. Multiple devices can be selected by repeating  this step.

     A OK mark appears beside the selected devices.

  9.  Select OK and press Enter  if the selection is OK.
  10.  Select a device and press Enter to start the tests.
  11.  Select Test All to test all devices.
  12.  Select Loop Test to run the tests in a repeated loop.

     A loop option menu appears in which a device loop or all-device  loop can be selected.  Select a device and press the Spacebar to select  a device. Repeat this step to select multiple devices.  Press Enter to start the diagnostic loop. If no device is selected,  all device tests are looped.

  13.  To exit the loop,  keep pressing Ctrl+Pause until the test exits.  A beep sounds to notify  that the exit interrupt is sensed  by the test program.

Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.