IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

FRU Removals and Replacements (TP 380XD, 385XD - 2635)

•  Important Notice / Screw Information
•  FRU Service Procedures

•  1010 DIMM Card and Backup Battery
•  1020 Battery Pack
•  1030 Hard Disk Drive
•  1040 Keyboard Unit
•  1050 Keyboard and Speaker
•  1060 CD-ROM Drive and Diskette Drive Assembly
•  1070 Diskette Drive and CD-ROM Drive
•  1080 LCD Unit
•  1090 Fan Assembly, CPU Card, Thermal Rubber
•  1100 Upper Shield Case
•  1110 Box Speaker and Microphone
•  1120 DC/DC Card
•  1130 System Board and PC Card Slot
•  1140 Battery Pack Latch
•  2010 LCD Front Cover
•  2020 LCD Panel
•  2030 LCD Inverter Card
•  2040 LCD Misc. Parts
•  2050 LCD Cable

•  The system board is sensitive to, and can

  be damaged by,   electrostatic discharge. Establish personal grounding  by touching a ground point with one hand before touching these units.

•  An electrostatic discharge (ESD) strap must be used to establish  personal grounding.

•  Do not damage any parts. Only certified, trained personnel  should service the computer.
•  The arrows in the 'Removals and Replacements' section show  the direction of movement to remove a FRU, or to turn a screw to release  the FRU. The arrows are marked in numeric order, in square callouts, to  show the correct sequence of removal.
•  When other FRUs must be removed before removing the failing FRU,  they are listed at the top of the page.
•  To replace a FRU, reverse the removal procedure and follow any  notes that pertain to replacement. See 'Locations' for internal  cable connections and arrangement information.
•  When replacing a FRU, use the correct screw size as shown in the  procedures.

•  Safety Notice 1
•  Safety Notice 4
•  Safety Notice 8

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.