|
+---+
|001| START
+---+
- Power off the system unit.
- Remove all adapter cards.
- Connect a hard disk drive with pre-loaded Windows 95 inside.
- Power on the system unit.
+---+
|002|
+---+
DO ANY POST MESSAGES, ERROR CODES, BEEPS, OR SYMPTOMS APPEAR?
(YES, read ahead, NO, go to Step 003)
- Go to 'Index of Symptoms, Messages, Error Codes, or Beeps'
- END.
+---+
|003|
+---+
DO ANY MESSAGES OR ERROR CODES DISPLAY AFTER POST?
(YES, read ahead, NO, go to STEP 004)
NOTE: If POST does not complete, go to Step 004
- Ensure that MS Windows 95 is properly installed.
- END.
+---+
|004|
+---+
- Perform the following under MS Windows 95.
NOTE: If an operating system other than MS Windows 95
is installed, the program screens and icons may differ from these
instructions.
1. Start MS Windows 95.
2. Select the Start icon.
3. Select Settings, the select Control Panel.
4. Select the Sound icon.
5. In the Sound window, select chimes from the Names field.
(To test other adapter card software, select an icon from a menu in
that software.)
+---+
|005|
+---+
IS THE PREVIEW BUTTON, OR ACTION IN OTHER SOFTWARE, SELECTABLE ON
THE SCREEN? (Show in BLACK and not GRAY?)
(YES, go to Step 006, NO, read ahead)
- Ensure that MS Windows 95 is properly installed.
- Go to Step 001
+---+
|006|
+---+
- Select the Preview button from the Sound window.
+---+
|007|
+---+
DO YOU HEAR ANY SOUND FROM THE SPEAKER?
(YES, read ahead, NO, go to step 008)
- The audio feature is functioning normally. Click Cancel to close the
dialog box. Exit MS Windows 95.
- If the symptom remains or has changed, go to 'Index of Symptoms, Messages...'
- END.
+---+
|008|
+---+
-Make sure that the volume control is not turned low.
- Make sure that the speaker and its adapter are not damaged.
- Make sure that the speaker is plugged in speak-out jack.
See 'System Board Layout'.
- If the error cannot be resolved, replace the system board.
- END.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.