Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Top Cover Removal



Top Cover Removal

Before you begin: Read Safety Information.

Note: You do not have to power-off the system to replace a hot swap fan.
 

-1- Thumbscrews
-2- Top cover


To remove the server top cover:

  1.  Turn off the server and all attached devices and  disconnect all external cables and power cords (see Preparing to Install Options).
  2.  Loosen the two thumbscrews -1- on the back edge of  the top cover.
  3.  Slide the top cover -2- slightly toward the rear of the  server, the cover will stop after about 25 mm (1 inch).  Lift the cover off the server and set the cover aside.

 
For proper cooling and airflow, replace the top cover before turning on the server. Operating the server for extended periods of time (over 30 minutes) with the top cover removed might damage server components.


Go to Server Door and Trim Bezels Removal.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.