Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Server Door and Trim Bezels Removal



Server Door and Trim Bezels Removal

Refer to the following illustration while you perform the steps in this procedure.
 

-1- Server door
-2- NetBAY3 bezel
-3- Media-bay trim bezel


To remove the server door:

  1.  Unlock and open the server door -1-.
  2.  Lift the server door up and off its hinges. Store the  door in a safe place.


To remove the NetBAY3 bezel (tower model only):

  1.  Unlock the NetBAY3 bezel -2-.
  2.  With the fingers on the ribbed area on the right side  of the NetBAY3 bezel -2-, grasp the right side of the  NetBAY3 bezel and pull it away from the pedestal.
  3.  Unhook the left side of the bezel from the server.  Store the bezel in a safe place.


To remove the media-bay trim bezel:

  1.  Release the two tabs at the bottom edge of the bezel  -3- and pull the bottom of the bezel slightly away  from the server.
  2.  Pull the bezel down to release the two tabs at the top  edge of the bezel. Store the bezel in a safe place.

Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.