|
|
|
Error Codes (Type 8644)
| Error Code/Symptom | FRU/Action |
|---|---|
| 101 | 1. System Board |
| (Timer tick interrupt failure) | 2. Microprocessor |
| 102 | 1. System Board |
| (Timer 2 test failure) | 2. Microprocessor |
| 106 | 1. System Board |
| (Diskette controller failure) | 2. Microprocessor |
| 110, 111 | 1. Memory DIMM |
| (Memory parity error) | 2. System Board |
| 114 | 1. Adapter Memory |
| (Option read only memory error) | 2. System Board |
| 121 | 1. Run Diagnostics |
| (Hardware error) | 2. System Board |
| 151 | 1. Run Diagnostics |
| (Real time clock failure) | 2. Battery |
| 3. System Board | |
| 161 | 1. Battery |
| (Real time clock battery failure) | |
| 162 | 1. Run Configuration/Setup |
| (A change in device | 2. Failing Device |
| configuration occured.) | 3. Battery |
| Possible causes: | 4. System Board |
| ° A new device installed | |
| ° A device moved to a different | |
| location/cable connection | |
| ° A removed or disconnected device | |
| ° A failing or unrecognized device | |
| ° An external device is not turned on | |
| ° Processor update code not installed | |
| or not be found. | |
| ° Running 'Erasing Lost or Forgotten | |
| Passwords' procedure that erases | |
| configuration data. | |
| ° CMOS memory checksum error | |
| 163 | 1. Run Configuration/Setup |
| (Time of day not set) | 2. Battery |
| 3. System Board | |
| 164 | 1. Run Configuration/Setup |
| (Memory size does not match CMOS) | 2. Dual Inline Memory Module |
| 3. Microprocessor | |
| 167 | 1. Perform the POST/BIOS (flash) |
| (A microprocessor was installed | Update procedure with latest |
| that is not supported by the current | POST/BIOS update |
| POST/BIOS) | |
| 175 | 1. System Board |
| (System board/microprocessor error) | 2. Microprocessor |
| 176 | 1. Run Configuration/Setup |
| (Computer cover or cable | |
| cover was removed without | |
| a key being used) | |
| 186 | 1. Run Configuration/Setup |
| (System board or | 2. System Board |
| security hardware error) | |
| 187 | 1. See POST error 162 |
| (Administrator password and | |
| see POST error 162) | |
| boot sequence have been cleared, | |
| 20X | 1. Memory installed incorrectly |
| (Memory controller error) | 2. Memory Module |
| 3. Microprocessor Board | |
| 4. System Board | |
| 301 303 | 1. Keyboard |
| (Keyboard failure) | 2. System Board |
| 601 | 1. Diskette Drive Cable |
| (Diskette drive error) | 2. Diskette Drive |
| 3. System Board | |
| 602 | 1. Try another startable |
| (Diskette damaged or | diskette that is formatted |
| formatted incorrectly.) | correctly and is in good condition |
| 2. Diskette Drive | |
| 604 | 1. Run Configuration/Setup |
| (Diskette Drive failure) | 2. Diskette Drive |
| 3. Diskette Drive Cable | |
| 4. System Board | |
| 662 | 1. Run Configuration/Setup |
| (Diskette drive | and Diagnostics |
| configuration error) | 2. Diskette Drive |
| 3. Diskette Drive Cable | |
| 4. System Board | |
| 762 | 1. Run Configuration/Setup |
| (Math coprocessor | 2. Processor |
| configuration error) | 3. System Board |
| 11XX | 1. Disconnect external cable on serial port. |
| (Serial port configuration | 2. Run Configuration/Setup |
| error) | 3. System Board |
| 1762 | 1. Run Configuration/Setup |
| (Hard disk configuration | 2. Cable |
| error) | 3. Diskette Drive |
| 4. System Board | |
| 178X | 1. Run diagnostics |
| (A hard disk drive or a | 2. Hard Disk Drive |
| primary or secondary IDE | 3. Primary or Secondary IDE Device |
| device error) | |
| 1800 | 1. Run Configuration/Setup |
| (PCI adapter interrupt | 2. Run EISA Configuration |
| request error) | 3. Failing Adapter |
| 4. System Board | |
| 1801 | 1. Run Configuration/Setup |
| (PCI adapter memory request error) | 2. Run EISA Configuration |
| 3. Failing Adapter | |
| 4. System Board | |
| 1802 | 1. Run Configuration/Setup |
| (PCI adapter I/O address | 2. Failing Adapter |
| request error) | 3. System Board |
| 1803 | 1. Run Configuration/Setup |
| (PCI adapter memory | 2. Failing Adapter |
| address request error) | 3. System Board |
| 1804 | 1. Run Configuration/Setup |
| (PCI adapter memory | 2. Move failing adapter to slot 1 or 2 |
| address request error) | 3. Failing Adapter |
| 3. System Board | |
| 1805 | 1. Remove Failing PCI Adapter |
| (PCI adapter ROM checksum error) | 2. System Board |
| 1850 | 1. Verify all adapter settings |
| (Plug and Play adapter hardware | in the Configuration/Setup |
| interrupt request error | Utility program. |
| See 'Adapters'.) | |
| 1851 | 1. Verify all memory resources |
| (Plug and Play adapter memory | in the Configuration/Setup |
| resources request error) | Utility program |
| 1852 | 1. Verify all adapter settings |
| (Plug and Play adapter I/O | in the Configuration/Setup |
| request error. | Utility program |
| See 'Config./Setup Utility Program Menus' | |
| See 'Adapters'.) | |
| 1853 | 1. Verify all adapter settings |
| (Plug and Play adapter memory | in the Configuration/Setup |
| request error. | Utility program |
| See 'Config./Setup Utility Program Menus' | |
| See 'Adapters'.) | |
| 1854 | 1. Verify all adapter settings |
| (Plug and Play adapter memory | in the Configuration/Setup |
| address request error. | Utility program |
| See 'Config./Setup Utility Program Menus' | |
| See 'Adapters'.) | |
| 1855 | 1. Remove all adapters and |
| (Plug and Play adapter read-only | reinstall them one at a time |
| memory (ROM) error). | Power-on the server after each |
| installation until you isolate | |
| the failing adapter | |
| 1856 | 1. Verify all adapter settings |
| (Plug and Play adapter DMA address | in the Configuration/Setup |
| request error. | Utility program |
| See 'Config./Setup Utility Program Menus' | installation until you isolate |
| See 'Adapters' | the failing adapter |
| 1962 | 1. Run Configuration/Setup / See > Tip H166357 |
| (No valid startup devices | 2. Check the cable connections. |
| where found). | 3. System Board. |
| 8603 | 1. Pointing Device |
| (Pointing device has been | 2. System Board |
| removed). | |
| I9990301 | 1. Run Configuration/Setup |
| (Fixed boot sector error, | |
| no operating system installed) |
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.