FRU Codes

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

FRU Codes

FRU Codes

If an error is detected by the diagnostics tests, a four-digit FRU code is displayed, along with an error code. The FRU code indicates two suspected FRUs. Replace the FRU that is indicated by the two leftmost digits first, and then replace the FRU indicated by the two rightmost digits . No FRU is assigned to code 00. If only one FRU is suspected, the other FRU code is filled with zeros. See the referenced page before replacing the FRU.

FRU Code	FRU/Action

10	1. Diskette Drive
	2. Bottom System Board
	3. Top System Board

12	Top System Board

14	Bottom System Board

20	Memory
	(See 'Memory Checkout')

32	External Keyboard

33	External Mouse

40	LCD Assembly
(See 'Disassembling the LCD Assembly')
45	External CRT

50	1. Reseat the Diskette Drive (FDD-1).
	2. Diskette Drive (FDD-1)

51	1. Reseat the Diskette Drive (FDD-2).
	2. Diskette Drive (FDD-2)

55	1. Insert a correctly
	formatted 2.0MB diskette
	into the Diskette Drive.

60	1. Reseat the Hard Disk Drive (HDD-1).
	2. Hard Disk Drive (HDD-1)

61	1. Reseat the Hard Disk Drive (HDD-2)
	on the docking station.
	2. Hard Disk Drive (HDD-2)

70	External PCMCIA

81	Internal Modem Card

91	If MultiPort II is installed:
	1. Reseat MultiPort II.
	2. MultiPort II.
	If Dock II is installed:
	1. Reseat Dock II.
	2. Dock II

NOTE: The device ID and error codes are used to indicate in detail the portion of the FRU that caused the error. If replacing a FRU does not correct a problem, see the device ID or error code from the previous failure. If they have changed, the new FRU might be defective or incorrectly installed.

If the problem remains after replacement of the FRUs, go to 'Undetermined Problems'

Back to

More INFORMATION / HELP is available at the IBM-HelpCenter

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.