BIOS release 1.1 for IS7-V  v1.0

Release information:

[ENGLISH]

1. Fixed the problem that specific CD-ROM device could not be correctly 
   detected when there is specific HDD connected onto the same IDE cable.
2. Fixed the problem that WD360 SATA HDD fails to boot up Windows XP when
   "Onchip Serial ATA" is set to "Enhanced Mode".
3. Changed the option wordings of "Boot Device" from "ZIP100" to "ZIP100/
   250" and from "USB-ZIP" to "USB-ZIP/LS120".
4. Added hot key wording to enter BIOS setup when full screen logo enabled.
5. Revised the wording of memory status from "DDR at Bank" to "DDR at DIMM"
   in system configuration table.
6. BIOS Compile date: 8/14/2003.


[中文]

1. 修正某些 CD-ROM 和某些特定IDE 硬碟接在同一條排線上時無法正常偵測的
   問題。(WD1200 / WD1800 / maxtor 6L80L4 搭配 Plextor PX 5232TX / 
   Teac DV-516EA / Pioneer DVR –A05)
2. 修正 SATA HDD(WD360) 在 "Onchip Serial ATA" 設為 "Enhanced Mode" 時,
   無法由 WindowsXP 開機。
3. 變更 Boot Sequence 選單的字串為 "ZIP100/250" 及 "USB-ZIP/LS120"。
4. 增加一訊息告知使用者當 full screen logo 開啟後如何進入 BIOS setup。
5. 修改 System Configurations Table 中字串 "DDR at Bank" 為 "DDR at DIMM"。
6. BIOS 日期: 8/14/2003。


*********************************  NOTE  *********************************

1. How to upgrade BIOS:

 a. Boot into MS-DOS or "Safe mode and command prompt" if you are using
    Windows95/98
 b. Run "is7v11.exe" to extract all files.
 c. Run "runme.bat"

   ***  Please notice that we suggest you flashing the bios with switches

           "/py /sn /cd /cp /cc /cks /R" or by "runme.bat".

 d. For more detail, please visit:

    http://fae.abit.com.tw/cht/download/bioshelp.htm  (Chinese)
    http://fae.abit.com.tw/eng/download/bioshelp.htm  (English)

2.After BIOS updated, pull off the power cord and then clear the CMOS data
  via jumper before restarting system please.


============================================================================