IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Setup for SMC Elite 16+

1.  DOS version 5.0 or higher is acceptable, with Windows 3.1.
    make a sub directory and copy all files from the dos_odi directory
    in the superdisk (setup disk for the elite Ethernet card).
   
2.  Select I/O base address 280, IRQ3, and RAM base address d0000 if
    the elite 16+ card is the only adapter in the system. No need to
    change the jumper setting at W1 and w2.
   
3.  If you have other adapters in the system or if want to use a
    different setting you must set the W1 jumper to soft. then run the
    ezsetup program from the superdisk and select the value you want
    (manual page 28).
   
4.  If you use a memory management utility (EMM, QEMM, 386MAX) you
    have to exclude the Ethernet cards RAM address space from your
    memory management driver by adding "/x=D000-D3FF" (or whatever your
    RAM address is) to the command line "DEVICE=C:\DOS\EMM386.EXE" in the
    config.sys file.
   
5.  You may run diagnose (f ROM superdisk) to check for conflicts.
   
6.  You may elect to type commands; lsl, smc8000, ipxodi, netx) one
    at a time to load the drivers and connect to the network. you can
    also add these commands to the end of the AUTOEXEC.BAT file to start
    the automatic load.
   

Sever Setup -

1.  Follow the instructions on pages 53 and 54 to install Netware 386
    v3.11 on a server.
   
2.  Use the ODI drivers in place of the IPX drivers.
   
3.  If you are running Windows, you must go into the Windows setup
    icon and select Novell Netware for the network.
   
4.  The server should be activated by typing SERVER at the DOS
    prompt before activating any workstation.
   

---

Back to  
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.