IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

CD-ROM Drive (Aptiva 2165 - SL-A)

•  Insert the diagnostics diskette into the diskette drive and make sure that there is no CD in the CD-ROM drive.
•  Select Interactive Tests menu, then select and execute CD-ROM Test.

  002 - DO YOU SEE A MESSAGE 'NO CD-ROM DRIVE OR MSCDEX DEVICE DRIVER INSTALLED.'?
   (YES, READ AHEAD. NO, GO TO 003.)

•  Exit the diagnostics program and power off the system.
•  Check and make sure that the CD-ROM drive power cable and audio and data cables are not  damaged and are connected properly.
•  Check and make sure that the CD-ROM drive driver is loaded correctly.
•  Load default settings.

  003 - DO THE TESTS OF OPEN/CLOSE TRAY BY DIAGNOSTICS PROGRAM AND
   BY DEPRESSING CD-ROM DRIVE BUTTON WORK?
   (YES, READ AHEAD. NO, GO TO STEP 006.)

•  Load a known good data CD into the CD-ROM drive and try to read its content by typing DIR at DOS prompt.

  004 - CAN A CD BE READ FROM THE CD-ROM DRIVE?
   (YES, THEN THE CD-ROM DRIVE FUNCTIONS NORMALLY. NO, READ AHEAD.)

•  Try reading the CD with a known good CD-ROM drive.

  005 - IS THE CD STILL NOT READABLE? (YES, READ AHEAD. NO, GO TO STEP 006.)

•  Replace system board.
•  End.

  006 -

•  Replace CD-ROM drive.
•  End.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.