|
|
|
+---+
|001|- START
+---+
° Power off the system unit and monitor.
° Remove all adapter cards.
° Make sure that the monitor I/O signal cable is properly connected to the system unit
and monitor.
° Make sure that the power cords are properly connected to the system unit
and monitor, and that the line voltage is correct.
° Make sure that the monitor contrast and brightness controls are not turned too low.
° Make sure that the diagnostics diskette is in the diskette drive.
° Power on the monitor, and wait 20 seconds.
° Power on the system unit.
NOTE: If the monitor was not sold together with the system unit, you may need
to refer to the service information provided with the monitor.
+---+
|002|- IS THE SCREEN READABLE?
+---+ (YES, READ AHEAD. NO, GO TO STEP 004)
NOTE: If the screen shows a blinking cursor with no memory count running,
answer this question 'No.'
° Select Interactive Tests from the Main Menu.
° Select and execute Video test from the menu.
° Follow the prompts and perform the video test.
° Go to 'Index of Symptoms, Messages, Error Codes, or Beeps'.
° You might have to adjust the monitor controls to obtain the best image.
+---+
|003|- DOES THE MONITOR SUCCESSFULLY PASS ALL TESTS?
+---+ (YES, READ AHEAD. NO, GO TO STEP 004)
° You have successfully completed the video diagnostics tests. If the problem
remains, go to 'Index of Symptoms, Messages, Error Codes, or Beeps'
° End.
+---+
|004|
+---+
° Power off the system unit.
° Remove the hard disk drive system cable.
° Power on the system unit.
+---+
|005|- IS THE SCREEN READABLE?
+---+
° Replace the monitor. If the symptom remains, replace the system board.
° End.
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.