|
+---+
|001|
+---+
- Check all drive and power supply connections for proper installation.
- Power-off the system unit.
- Check the power cord for continuity. Replace if necessary.
- Check for the correct line voltage from the power outlet, and verify that
the voltage selector switch (if present) is set for the correct voltage.
- Power-on the system unit.
DOES THE POWER SUPPLY FAN RUN ?
Yes No
| +-+-+
+-+-+ |002| Go to Step 004
|003| +---+
+---+
Go to Step 009
+---+
|004|
+---+
- Disconnect the powercord from the back of the system unit.
- Disconnect all power and switch cable connectors from the system board
and the power supply.
- Disconnect the power connectors to all drives.
- Locate the power supply on/off cable connector (three wire connector) and
make a connection (jumper) between the black and white wires.
- Reconnect the power cord.
DOES THE POWER SUPPLY FAN RUN ?
Yes No
| +-+-+
+-+-+ |005| Replace the power supply.
|006| +---+
+---+
- With the system powered on and the power supply fan running, check the
voltages at the power supply connectors for the system board and all drive
connectors, as shown in the following figures.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.