|
+---+
|001| START
+---+
- Insert the diagnostics diskette into the diskette drive and ensure that
there is no CD in the CD-ROM drive.
- Select Interactive Tests menu, then select and execute CD-ROM Test.
+---+
|002|
+---+
DO YOU SEE A MESSAGE 'NO CD ROM DRIVE OR MSCDEX DEVICE DRIVER INSTALLED?'
(YES, read ahead, NO go to 003.)
- Exit the diagnostics program and power off the system.
- Check and ensure that the CD-ROM drive power cable and audio and data
cables are not damaged and are connected properly.
- Check and ensure that the CD-ROM drive driver is loaded correctly.
+---+
|003|
+---+
DO THE TEST OF OPEN/CLOSE TRAY BY DIAGNOSTICS PROGRAM AND BY DEPRESSING
CD_ROM DRIVE BUTTON WORK?
(YES, read ahead, NO, go to Step 006.)
- Load a known good data CD into the CD-ROM drive and try to read its
content by typing DIR on DOS prompt.
+---+
|004|
+---+
CAN A CD BE READ FROM THE CD-ROM DRIVE?
(YES, then the CD-ROM drive functions normally, NO, read ahead.)
- Try reading the CD with a known good CD-ROM drive and try read it again.
+---+
|005|
+---+
IS THE CD STILL NOT READABLE?
(YES, read ahead, NO, go to Step 006.)
- Replace system board.
- END.
+---+
|006|
+---+
- Replace CD-ROM drive.
- END.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.