 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Module Test Menu
Module Test Menu
A customized setup configuration (other than default settings) might
exist on the computer you are servicing. Running the Setup Utility program
might alter those settings. Note the current configuration settings
and verify that the settings are in place when service is complete. To
start the Setup Utility program see 'Setup Program (Type 8639)'.
At the start of the diagnostic tests, the Module Test Menu is displayed.
Normally, all adapters and devices installed in the computer are
highlighted on the menu.
- If an adapter or device that is not installed in the computer is highlighted on the menu, use the procedure in 'Undetermined Problem' to find
the problem.
- If an adapter or device is installed in the computer and is not
highlighted on the menu, you have one of the following conditions:
- The diagnostic code for the adapter or device is not on the
diagnostic diskette. Run the diagnostics provided with that
device.
- The SCSI controller failed (on the system board or SCSI adapter).
- An unrecognizable adapter is installed.
- The missing device is defective or it requires an additional diskette
or service manual.
- A defective adapter caused the device not to be highlighted on the
menu.
If a device is missing from the list, replace it. If this does not
correct the problem, use the procedure in 'Undetermined Problem'.
Back to 
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.