This is not an IBM Part. For information only.
| I/O Baseaddress | I/O Addressrange | Advanced WavEffets Synthesizer | IOS0 | IOS1 |
|---|---|---|---|---|
| 220H (default) | 220H - 233H | 620H - 623H A20H - A23H E20H - E23H |
X | X |
| 240H | 240H - 253H | 640H - 643H A40H - A43H E40H - E43H |
X | |
| 260H | 260H - 273H | 660H - 663H A60H - A63H E60H - E63H |
X | |
| 280H | 280H - 293H | 680H - 683H A80H - A83H E80H - E83H |
MPU-401 - MIDI Connector (X = Jumper present)
| I/O Baseaddress | I/O Addressrange | MSEL |
|---|---|---|
| 300H | 300H - 301H | |
| 330H (default) | 330H - 331H | X |
MIDI Connector (X = Jumper present)
| MIDI Connector | MFBEN |
|---|---|
| Active (default) | X |
| Inactive |
IDE CD-ROM - Ports (IDE SETTING) (X = Jumper present)
Secundary Tertiary
o o o o o o
| (default) |
o o o o o o
IDEIO
100
101
| IDE Port | I/O Addressrange | IDEIO0 | IDEIO1 |
|---|---|---|---|
| Secundary (default) | 170H-177H, 376H-377H | X | |
| Tertiary | 1E8H-1EFH | X | |
| Quaternary | 168H-16FH | ||
| Disabled | X | X |
IRQ for CD-ROM - Ports (IDE_IRQ)
o o o o o o o o o o o o o o o o o o o o o o o o o
| | | | |
o o o o o o o o o o o o o o o o o o o o o o o o o
IRQ 15 IRQ 10 IRQ 11 IRQ 12 IRQ 14
Joystick Connector (X = Jumper present)
| Joystick Connector | JYEN |
|---|---|
| Active (default) | X |
| Inactive |
DRAM Expansion (X = Jumper present)
| DRAM | DRAM_EN Pin |
|---|---|
| 512KB DRAM (on card default) | 2-1 |
| SIMM present | 3-2 |
Connector Pin Layout
CD Connector CD_IN
Pin 1 Ground Pin 2 CD-Left channel in
Pin 3 Ground Pin 4 CD-Right channel in
CD Audio-Connector
Pin 1 CD-Left channel in Pin 2 Ground
Pin 3 Ground Pin 4 CD-Right channel in
PC Speaker Connector PC_SPK
Pin 1 +5Vdc Pin 2 PC Speaker Out
SPDIF Connector (Sony/Philips Digital Interface Format)
Pin 0 Digital Out Pin 1 Ground
Audio Extension Connector (JP20)
Pin 1 Speaker Ground
Pin 2 Speaker Right Channel
Pin 3 Speaker Left Channel
Pin 4 Speaker Out Feedback Left Channel
Pin 5 Speaker Out Feedback Right Channel
Audio Extension Connector (JP21)
Pin 1 Speaker Out, Right Channel
Pin 2 Speaker Out Feedback, Right Channel
Audio Extension Connector (JP22)
Pin 1 Ground
Pin 2 Microphone Input, Ground
Pin 3 Microphone Input, Left Channel (0.004 - 0.7 Vrms)
Diagnostic
There should exist a directory \SB16. Inside this directory
should be a file DIAGNOSE.EXE (if correct installed).
Start DIAGNOSE from a DOS prompt, and watch the output shown on display.
If there is a Token-Ring installed, you might have an address - conflict with
SoundBlaster set to default 220H address, change it to 240H and run DIAGNOSE.
AUTOEXEC.BAT (added lines, sample)
SET BLASTER=A220 I5 D1 H5 P330 E620 T6
SET SOUND=C:\SB16
SET MIDI=SYNTH:1 MAP:E MODE:0
C:\SB16\DIAGNOSE /S
C:\SB16\AWEUTIL /S
C:\SB16\SB16SET /P /Q
CONFIG.SYS (added lines, sample)
DEVICE=C:\SB16\DRV\CSP.SYS /UNIT=0 /BLASTER=A:220
C:\SB16\DRV\CTSB16.SYS /UNIT=0 /BLASTER=A:220 I:5 D:1 H:5
C:\SB16\DRV\CTMMSYS.SYS
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.