|
|
|
Error Codes (QAPlus/PRO)
| Error Code/Symptom | FRU/Action |
|---|---|
| 0000 | 1. Be sure the adapter Device |
| SCSI Adapter not enabled. | and Bus Master fields are enabled |
| in the PCI configuration program. | |
| Refer to the documentation that | |
| was shipped with the computer. | |
| 002X | 1. SCSI Adapter |
| 008X | 1. Check SCSI terminators for |
| Check for proper installation | proper installation |
| of SCSI terminators. | 2. SCSI Cable |
| 3. SCSI Terminator | |
| 4. SCSI Device | |
| 5. SCSI Adapter | |
| 0115 | 1. System Board |
| Protected mode cannot be enabled. | |
| 0164 | 1. Run Setup and ensure |
| POST detected a base memory or expansion | the memory size is correct |
| memory size mismatch | 2. Run the Expanded |
| Memory Diagnostic tests. | |
| 0601 | 1. Set Configuration |
| Diskette configuration error | |
| 0610 | 1. Diskette Drive |
| Cannot find diskette controller | 2. Diskette Drive Cable |
| for drive A. | 3. Diskette Drive Adapter if installed |
| 4. System Board | |
| 0612 | 1. Diskette Drive |
| Cannot find diskette controller | 2. Diskette Drive Cable |
| for drive B. | 3. Diskette Drive Adapter if installed |
| 4. System Board | |
| 0616 | 1. Diskette Drive Adapter |
| Diskette drive reset failed. | |
| 0632 | 1. Diskette Drive A |
| Diskette drive 0 seek failure | |
| 0642 | 1. Diskette Drive B |
| Diskette drive 1 seek failure | |
| 0653 | 1. Format diskette |
| Diskette not formatted or defective | 2. Diskette |
| 0655 | 1. Diskette Drive |
| Diskette drive controller failed. | 2. Diskette Drive Cable |
| 3. Diskette Drive Adapter if installed. | |
| 4. System Board | |
| 107X | 1. Check SCSI terminators |
| Check for proper installation | for proper installation |
| of SCSI terminators. | 2. SCSI Cable |
| 3. SCSI Terminator | |
| 4. SCSI Device | |
| 5. SCSI Adapter | |
| 1701 | 1. Hard Disk Drive |
| Hard disk drive failed. | |
| Press F1 to restart the system. | |
| 1702 | 1. Hard Disk Drive Adapter |
| Hard disk drive controller error | if installed |
| 2. System Board | |
| 1704 | 1. Hard Disk Drive Adapter |
| Hard disk drive configuration error, | if installed |
| controller failed | 2. System Board |
| 1715 | 1. Run Setup and enter the |
| The Hard Disk Drive Configuration | correct hard disk drive |
| information is not correct | information |
| 1726 | 1. Hard Disk Drive |
| Hard disk drive read error | |
| Press F1 to restart the system | |
| 182X | 1. SCSI Adapter |
| 190X | 1. SCSI Cable |
| Ensure that each SCSI device is | 2. SCSI Terminator |
| properly installed and powered-on. | 3. SCSI Device |
| 4. SCSI Adapter | |
| 1XXX | 1. SCSI Adapter |
| (not listed above) | |
| 221X | 1. SCSI Cable |
| Ensure that each SCSI device is | 2. SCSI Terminator |
| properly installed and powered-on. | 3. SCSI Device |
| 4. SCSI Adapter | |
| 221X 224X | 1. SCSI Adapter |
| 2401 | 1. Correct the switch setting |
| The monochrome/color switch is not | 2. Display Adapter |
| set correctly. | |
| 3XXX | 1. Check SCSI terminators for |
| Check for proper installation of | proper installation |
| SCSI terminators. | 2. SCSI Cable |
| 3. SCSI Terminator | |
| 4. SCSI Device | |
| 5. SCSI Adapter | |
| 4XXX | 1. SCSI Cable |
| Ensure that each SCSI device is | 2. SCSI Terminator |
| properly installed and powered-on. | 3. SCSI Device |
| 4. SCSI Adapter | |
| 6XXX | 1. SCSI Device |
| GP_COM | 1. System Board |
| The serial port test detected | |
| an error. | |
| GP_FDU | 1. Diskette Drive |
| The diskette drive test detected | 2. System Board |
| an error. | 3. Diskette Drive Cable |
| 4. Diskette | |
| GP_HDU | 1. Hard Disk Drive |
| The hard disk drive test detected | 2. Hard Disk Drive Cable |
| an error. | 3. Hard Disk Drive Adapter |
| (if installed) | |
| 4. System Board | |
| GP_KBD | 1. Keyboard |
| The keyboard test detected | 2. System Board |
| an error. | |
| GP_MBD | 1. System Board |
| The system board test detected | 2. Processor |
| an error. | 3. Real-Time Clock Assembly |
| GP_MEM | 1. Memory Module Kit |
| The memory test detected | 2. System Board |
| an error. | |
| GP_PDV | 1. Mouse |
| The mouse test failed. | 2. System Board |
| GP_PRT | 1. Printer |
| The printer test detected | 2. System Board |
| an error. | |
| GP_VID | 1. Video Adapter |
| The video test detected | 2. System Board |
| an error. | 3. Color Display |
| GRPCDR | 1. CD-ROM |
| The CD-ROM test detected | 2. System Board |
| an error. |
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.