Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Resetting the Adapter Configuration (ServeRAID)



Resetting the Adapter Configuration


The RAID configuration information stored in the adapter NVRAM is critical to reliable operation of the disk-array. Therefore, to protect the integrity of the configuration information, copies of the configuration information are stored in the adapter EEPROM and on each hard disk drive in a Rebuild or Online state that is defined in the adapter NVRAM configuration. Each time the configuration information is changed, all corresponding copies are updated.

During POST, if the configuration information in the adapter NVRAM, EEPROM, and hard disk drive does not match, an error message appears. You can view each configuration to determine which you want use.

The Init/View/Synchronize Configuration menu enables you to viewor reset the following parameters:


To initialize, reset, or view the adapter configuration:
  1.  Start the ServeRAID configuration program (see 'Starting the ServeRAID Configuration Program')
  2.  Select Advanced Functions from the Main Menu.
  3.  Select Init/View/Synchronize Config.
  4.  Select your choice from the next menu, then press Enter

     

  5.  Follow the instructions on the screen.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.