Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

SCSI Backplane Component Locations



SCSI Backplane Component Locations

The following simplified layout of the SCSI backplane identifies the components. Refer to this figure when you set the jumpers on the backplane.
 

1 Wide (16-bit) SCSI connector
2 Option jumper block (J10)
3 SCSI hot-swap drive connectors (on reverse side of backplane)
4 Repeater card connector
5 Power connector


SCSI Backplane Option Jumpers

The option jumper block on the SCSI backplane defines the SCSI IDs for hot-swap drives. See the (above) illustration for the location of the option jumper block (J10). Table 11 summarizes the settings for the SCSI backplane option jumper block (J10).

The below table shows the SCSI IDs that you can use for hot-swap drives.

SCSI IDs for Hot-Swap Drives

J10
Pins
5-6
J10
Pins
11-12
Bay 1 Bay 2 Bay 3 Bay 4 Bay 5 Bay 6
No
jumper
No
jumper
0 1 2 3 4 5
No
jumper
jumper 5 4 3 2 1 0
jumper No
jumper
13 12 11 10 9 8


Notes:

  1.  No jumper on pins 5-6 and 11-12 is the default.
  2.  Jumpers on pins 5-6 and 11-12 is not supported.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.