 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Installing Devices in the NetBAY3
Installing Devices in the NetBAY3
This appendix contains information about installing devices
in the NetBAY3.
Note:
The illustrations in this appendix do not show the
server on top of the NetBAY3, however, you do not
need to remove the NetBAY3 to install devices.
General Considerations: You can install three
types of devices in the NetBAY3:
- Devices, such as the IBM EXP10, that sit on side rails
- Cantilevered devices, such as a power distribution
unit (PDU), that are screwed to the front or rear of the
NetBAY3
- Devices that sit on the NetBAY3 base plate
Note:
- To allow the NetBAY3 front bezel to close,
devices with handles must not protrude out more
than 56 cm (2.2 in.). The following illustration of
the front bezel top-view cross section shows the
clearances.
- All device cables must exit from the rear of the
NetBAY3.
Back to 
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.