External Display (3547)

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

External Display (3547)

External Display

If the screen is rolling, replace the external display. If the problem is not corrected, replace FRUs in the following order one at a time until the problem is corrected:

NOTE: If the replaced parts did not resolve the problem, put the original parts back in the SelectaDock Docking System. Do not replace non-defective parts.

If the external display is attached to the SelectaDock Docking System:
1. Main Card of SelectaDock Docking System
If the external display is attached to the display adapter:
1. Display adapter
2. Main card of SelectaDock Docking System
3. Riser card

If the screen is not rolling, do the following to run the display self-test:

Power-off SelectaDock Docking System and the external display.
Disconnect the external display signal cable from the SelectaDock Docking System.
Power-on the external display.
Turn the contrast control to its maximum position.
Turn the brightness control to its center position.

Check for the following conditions:

The screen should be white or light gray, with a black margin, see the appropriate display manuals for the correct self-test condition.
The screen contrast and brightness controls should vary the intensity of the screen.

If the external display does not meet these specifications, replace the external display.

If the external display meets these specifications, replace FRUs in the following order one at a time until the problem is corrected.

NOTE:

If the external display is attached to SelectaDock Docking System:
1. Main card of SelectaDock Docking System
2. External display
If the external display is attached to the display adapter:
1. Display adapter
2. Main card of SelectaDock Docking System
3. Riser card
4. External display

Back to

More INFORMATION / HELP is available at the IBM-HelpCenter

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.