Printer (3547)

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

Printer (3547)

Printer

Test the printer by connecting it to the computer before testing it on the SelectaDock Docking System.

Make sure the printer is correctly connected and the power is turned on.
Run the printer self-test.

If the printer self-test does not run correctly, the problem is in the printer. Refer to the printer service manual.
If the printer self-test runs correctly, connect a wrap plug on the parallel connector on the rear of SelectaDock Docking System and run the advanced diagnostic tests to determine the failing FRU.
If the advanced diagnostic tests (with the wrap plug connected) did not detect a failure, replace the printer cable.
If the problem is not corrected, do one of the following:

If the printer is attached to the parallel connector of SelectaDock Docking System, replace the main card of SelectaDock Docking System.
If the printer is attached to the parallel connector on the adapter, replace the FRUs in the following order one at a time until the problem is corrected:
NOTE:If the replaced parts did not resolve the problem, put the original parts back in the SelectaDock Docking System. Do not replace non-defective parts.
1. Adapter
2. Main Card of SelectaDock Docking System

Back to

More INFORMATION / HELP is available at the IBM-HelpCenter

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.