 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
1060 Status Indicator
1060 Status Indicator
Do not pull the status indicator cable.
The cable can be damaged if the indicator
is disconnected (in step 2)
without releasing the latch.
The status indicator has three latches on its rear
side and one on its front side.
For step 3, do the following:
- Release the rear latches by pushing each one with your thumb,
as shown in the figure.
(The circles in the figure show the locations
of the three latches.)
- Release the front latch.
- Lift the indicator.
NOTE: When replacing the indicator,
insert the flexible cable straight into the connector until
the head of the cable stops.
Slide both ends of the latches at the same time
to make sure that the cable is correctly inserted.
Use the following table for reference when replacing parts.
| Step |
Location (Quantity) |
Length |
| 1 |
Indicator bracket (2) |
4 mm |
NOTE: Make sure you use the correct screw. Screw Size Chart
Back to 
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.