Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Replacing the Microphone and Sleeve



Replacing the Microphone and Sleeve
 

The right hinge should already be installed. To replace the microphone and cables, perform the following steps:
  1.  Insert the  microphone wires into the small  slit in the backlight cable protective sleeve.
  2.  Holding the microphone and sleeve near the hinge,  insert the yellow backlight cable  through the slit  in the sleeve, and then  the brown cable.  Do not allow the microphone cable to twist around the backlight cables.
  3.  Slip the sleeve into  place so that the flange is inside the  computer lid, toward the LCD.
  4.  Insert the microphone  into the space between the hinge and the LCD, with the  foam block against the right side of the space.  Press the block gently to ensure that it is completely inserted.

     Make sure that the foam does not cover the microphone diaphragm.  When installed correctly, the microphone lines up with the two  small slots in the bezel.

More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.