1.40

1. CPU Microcode updated.
2. Celeron 2.8 GHz CPU should be shown correctly.


1.30

1. With two Promise IDE RAID card FastTrak Tx2000 installed, both 2 cards should be working.
2. Vcore value should be shown correctly.
3. When power on the system right after shutting down, system should boot up correctly.
4. CPU temperature should be shown correctly.
5. COM port mouse should be working if USB Legacy Support is enabled.

1.20

1. Hardware Monitor should show correct CPU voltage.
2. System should operate well after resuming from "suspend to RAM".
3. Set "Floppy Drive Seek" to default "Enabled".


1.10

1.System would operate well with Intel FSB 533MHz 2.4GHz CPU.