Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

174 POST ERROR and MICROPROCESSOR ERROR in DIAGNOSTIC



Subject: 174 POST ERROR and MICROPROCESSOR ERROR in DIAGNOSTIC
Updated PS/2 Server RETAIN Tip: 

    Record number:       H132024
    Device:              D/T9585
    Model:               M
    Hit count:           UHC00015
    Success count:       USC0000
    Publication code:    PC50
    Tip key:             008
    Date created:        O98/11/03
    Date last altered:   A99/01/21
    Owning B.U.:         USA


Abstract: 174 POST ERROR and MICROPROCESSOR ERROR in DIAGNOSTIC


TEXT:

174 POST Error and Microprocessor Error in Diagnostic


SYMPTOM:

Customer will see a 174 error at POST. Reference disk will display 0 MHz for the
processor speed. Diagnostics when ran will display the following error:

(slot =0, server 85 system board... error code = 00015400, a microprocessor error
occurred at test step 115, most likely causes are Microprocessor, or system board)


PROBLEM ISOLATION AIDS:


PROCEDURE:

Customer must first Contact The IBM HelpCenter at 1 800-772-2227, to order the required socket interposer.

NOTE: EMEA Contact Numbers are available on the web at the following URL:

http://www.pc.ibm.com/support?page=YAST-3P2QYL

To install interposer onto processor, first ground yourself, then remove processor
and interposer from packaging remembering to avoid contact with the pins.
Remove processor fan assembly by gently squeezing together the two retaining clips.
Keeping the retainer clips squeezed together, slowly lift up the corner, pivoting it
against the opposite corner. When the fan assembly is approximately at a 45 degree angle,
left straight up from the processor.
Aligning the pins of the overdrive to the interposer socket, firmly and evenly press the
processor into the interposer. There should be a slight gap between interposer and processor.
Reconnect fan to processor.
Remove 486 processor using chip removing tool.
Line the blunt edge of Pentium processor with that of the processor socket in the system.
Once all pins are aligned in the socket, lock socket release arm into place and secure it.
Restart system.
System will boot to configuration error. Boot system to Reference diskette.

NOTE: The processor is labeled 0 MHz on reference diskette configuration.
Save configuration, and Restart the system.


WORKAROUND:

Booting the system to the reference diskette and saving the configuration will correct
the 174 error at POST. No workaround for Diagnostics, and 0 MHz processor speed.


DETAILS:

BIOS and Diagnostic changes are required to fix problem.
There are no current plans to rewrite either.
The system BIOS will incorrectly label processor, but processor will run at proper speed.


TRADEMARKS:

Other company, product and service names may be the trademarks or service marks of others.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.