Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

SCSI BIOS Error: "SCSI Termination NOT FOUND"



Subject: SCSI BIOS Error: "SCSI Termination NOT FOUND"
The following Retain Tip is re-released with updates or corrections. 

     Record number:       H163815
     Device:              D/T6898
     Model:               M
     Hit count:           UHC00029
     Success count:       USC0000
     Publication code:    PC50
     Tip key:
     Date created:        O98/06/01
     Date last altered:   A98/06/15
     Owning B.U.:         USA


Abstract: SCSI BIOS Error: "SCSI Termination NOT FOUND"

SYMPTOM:

When booting the system, the SCSI BIOS returns the following, or similar error message:

"SCSI Termination Not Found"

The SCSI subsystem will not be enabled.


PROBLEM ISOLATION AIDS:

This tip applies to IBM IntelliStation M-Pro Series 6898 and Netfinity 3500 Series 8644 systems.

The "SCSI Termination Not Found" error message will manifest itself as an "out-of-box" error in new systems preconfigured for SCSI operation.

In systems preconfigured for IDE operation, the SCSI error message may not be seen until the on-board SCSI BIOS is enabled in the F1 Setup utility, and a SCSI hardfile is installed.

Planar FRU numbers exposed to this condition are P/N 93H7269 and P/N 08L0046 (for 333MHz Models).


FIX:

Follow normal problem determination steps to eliminate possible SCSI adapter, SCSI cable, or SCSI hardfile errors.

If the "SCSI Termination Not Found" error persists, replace the system board with FRU P/N 08L0606.

Note: When servicing Netfinity 3500, Type 8644-1xx/2xx systems, see Retain Tip H106654 for instructions on planar replacement, and saving the CMOS configuration.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.