Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

CLIENT NOT CONNECTED after HOT-ADDING A 10/100 ETHERNET NIC



Subject: CLIENT NOT CONNECTED after HOT-ADDING A 10/100 ETHERNET NIC
New Netfinity server RETAIN Tip: 

    Record number:       H164726
    Device:              D/T8680
    Model:               M
    Hit count:           UHC00000
    Success count:       USC0000
    Publication code:    PC50
    Tip key:
    Date created:        O98/09/17
    Date last altered:   A98/09/17
    Owning B.U.:         USA


Abstract: CLIENT NOT CONNECTED after HOT-ADDING A 10/100 ETHERNET NIC


SYMPTOM:

A LAN adapter can be hot-added to a PCI slot, but the client connected to the adapter will not be visible in Network Neighborhood until the system is rebooted.

The client can not be seen in Network Neighborhood because the client will not connect with the system until the reboot.


PROBLEM ISOLATION AIDS:


FIX:

No Permanent Fix is Available


WORKAROUND:

This defect is reproduced only on NT setups where the server is not yet started. In order to start the server, an adapter must be installed within NT. The MS Loopback adapter may be installed to start the server and then the IBM Netfinity 10/100 Ethernet adapter may be Hot-added. See "DETAILS", section below, for more information on the MS Loopback adapter.

Adding of anything but a network card driver while in the network applet during a hot add is also unsupported. For example: Changing machine name, adding a protocol, or adding a service will require NT to reboot.


DETAILS:

More information regarding whether or not the MS Loopback Adapter is installed:

  1.  If NT is loaded on a Netfinity 7000 M10, Type 8680, system  with the MSLoopback default driver ENABLED, the user will be  successful in Hot-adding a Lan adapter, connecting a client,  viewing the server from the client, and viewing the client from  the server, and finally running a session of LanNT from the  client to the server.
  2.  If NT is loaded on a Netfinity 7000 M10, Type 8680, system  with the MSLoopback default driver DISABLED, the user will be  successful in Hot-adding a Lan adapter, connecting a client,  viewing the server from the client, and running a session of  LanNT from the client to the server. The user will NOT,  however, be able to view the client attached to the card from  the server.


This defect was produced with the following IBM Fault Tolerant Hot plug code:

  1.  IBM Netfinity 10/100 Fault Tolerant Driver, version  4.02.005, date 8/20/98
  2.  IBM Fault Tolerant Management, PCI Hot Plug Solution,  version 2.08.18.0, date 8/18/98
  3.  IBM Failover DMI Agent, version 2.0.0.54, date 7/24/98


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.