Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

NETFINITY 3500: EMC CLIP REMOVAL TO FIX FLOPPY DRIVE ERROR



Subject: NETFINITY 3500: EMC CLIP REMOVAL TO FIX FLOPPY DRIVE ERROR
New Netfinity server RETAIN TIP: 

     Record number:       H164143
     Device:              D/T8644
     Model:               M
     Hit count:           UHC00000
     Success count:       USC0000
     Publication code:    PC50
     Tip key:
     Date created:        O98/07/10
     Date last altered:   A98/07/13
     Owning B.U.:         USA


Abstract: NETFINITY 3500: EMC CLIP REMOVAL TO FIX FLOPPY DRIVE ERROR


SYMPTOM:

The following error is displayed when booting the System to a bootable floppy diskette or accessing the floppy drive from the Operating System:

"General failure reading drive A"
"Retry / Abort / Cancel"


PROBLEM ISOLATION AIDS:


FIX:

The EMC Clip responsible for the Floppy drive failure has been removed from the Systems presently manufactured.


WORKAROUND:

Remove the EMC (electromagnetic compatibility) clip connected to the 3.25" DASD Cage below the Floppy Drive as follows:

  1.  Power-Off and disconnect all peripheral devices connected to  the System, then disconnect the System power cord.
  2.  Remove the Floppy Drive (refer to the Users Manual or the  HMM section: "Installing or removing Internal drives")
  3.  Locate the copper colored EMC clip located and attached  to the inside of the bottom of the DASD cage the Floppy  drive was located. The Clip will be positioned at center  from the sides and one third from the front of the cage.
  4.  Remove the EMC clip using needle nose pliers. Removal will  only require a average pull on the EMC clip.
  5.  Re-install the Floppy Drive (refer to the User's Manual  or the HMM as in step 2).
  6.  Re-connect the System power cord, and peripheral devices,  power-on the peripheral devices, then power-on the System.
  7.  Access a known good diskette from the Operating System or  boot the System from a bootable diskette to verify proper  operation of the Floppy Drive.


DETAILS:

The Floppy Drive may fail if the EMC clip exerts pressure on the motor spindle of the drive.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.