Auto Setup for the PC

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

Auto Setup for the PC:

Check the operating system installed on your PC and go to the respective section.

If only PC-DOS is installed on your PC:
Perform the auto setup procedure for PC-DOS.
If Microsoft Windows 3.1 is installed on your PC as well as PC-DOS:
1. If you are going to use full-screen on your PC, perform the auto setup procedure for PC-DOS.
2. Perform the auto setup procedure for Windows.
If Windows 95 or Windows NT is installed on your PC:
1. If you are going to use full-screen on your PC, perform the auto setup procedure for PC-DOS in full-screen mode.
2. Perform the auto setup procedure for Windows.
If Operating System/2 (OS/2) is installed on your computer:
1. If you are going to use full-screen on your PC, perform the auto setup procedure for PC-DOS.
2. Perform the auto setup procedure for OS/2.
  (You do not need to perform the auto setup procedure for Windows.)

NOTE:

If your PC does not run with the setup option diskettes shipped with the monitor, refer to Quick Setup.
Before you begin the auto setup for your PC:
- Make a backup copy of the setup option diskettes shipped with the monitor.
- Make sure the PC 5 video mode is set in the range of the supported screen resolution shown in the table, your PC's screen mode is not set in the range, adjust frequencies to put it in the scan range specified in the operating manuals for your PC or the operating system.
- Perform the auto setup for each screen mode you use.

Back to

More INFORMATION / HELP is available at the IBM-HelpCenter

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.