IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

1030 Power Supply Unit (3546)

•  Main Cabinet Group
•  Remove all cables from the connectors on the riser card.  (Refer to 'Riser Card' for the location of these connectors.)
•  Remove all cables from the connectors on the main card.  (Refer to 'Main Card' for the location of these connectors.)
•  1 2 3 4 5
•  Lift up and turn over the power supply assembly then release the  cables on the rear of the rack 6.
•  Remove all remaining cables from the connectors on the main card.
•  Turn the power supply assembly to the upright position.
•  7 8 9   (Do not forget to install the washer on the left screw at replacement  in step 9.)

Step	Color/type (quantity)	Length
2	2.Pan head screw (1) Diameter: 3 mm (0.12 in.)	3.8 mm (0.31 in.)
2	2.Flat head screw (1) Diameter: 3 mm (0.12 in.)	3.6 mm (0.24 in.)
4	Pan head screw (6) Diameter: 3 mm (0.12 in.)	6 mm (0.24 in.)
5	Pan head screw (2) Diameter: 3 mm (0.12 in.)	4 mm (0.16 in.)
7	Binding head tapping screw (2) Diameter: 3 mm (0.12 in.)	6 mm (0.24 in.)
8	Black binding head machine screw (4) Diameter: 3 mm (0.12 in.)	6 mm (0.24 in.)
9	Pan head screw (2) Diameter: 3 mm (0.12 in.)	6 mm (0.24 in.)

Replacement

NOTE: The intersecting end of the SCSI cable should be inserted into the connector on the riser card. See 1

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.