Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Display



Display

The following provides some general display information for the computer. For specific display service procedures and other display information, refer to the Monitor Hardware Maintenance Manual (P/N 83G7827 form number S71G-4197) 

  The Power Series computer DOES NOT Support these displays: 6312, 6314, 6317, 6318, 6319. Attaching these displays to a Power Series computer can DAMAGE the display

The following is a Quick Test for the display:
  1.  Power off the computer and display.
  2.  Disconnect the display signal cable.
  3.  Power on the display.
  4.  Turn the brightness and contrast controls to their maximum setting.
  5.  Check for the following conditions:  If the display test fails, replace or service the display. If that does not solve the  problem or if the display test is successful, do the following.
  6.  Remove the L2 Cache Card (if installed).
  7.  Retry the test that failed.


NOTE: During the first two or three seconds after the display is powered on, the following might occur while the display synchronizes with the computer.

These sounds and display patterns are normal, do not replace any parts. Also, a noticeable odor might occur on new displays or displays recently removed from storage.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.