Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Installing the Automatic Bus Transfer in a Netfinity 7000 M10



Installing the Automatic Bus Transfer in a Netfinity 7000 M10

Perform the following steps to install the automatic bus transfer.


Step 1. Remove the Power Supplies

Refer to the illustration while performing the steps in this procedure.

 
  1.  Perform the steps in "Preparing for the Installation".
  2.  Set the power switches -1- on all power supplies to the Off position.
  3.  Remove the two power supply shipping screws -2- from the power supply handle.
  4.  Pull the power supply handle -3- all the way out until the latches  disengage. Slide the power supply -4- out of the chassis.
  5.  Remove the other power supplies.


Step 2. Remove the 5-Volt Regulator Card

 
  1.  Remove the two screws -1-.
  2.  Pull the regulator card -2- out of the server.


Step 3. Remove the AC Power Assembly

 
  1.  Support the power assembly from the bottom with your hand and remove  the four screws -1-.
  2.  Pull the assembly -2- out of the server.


Step 4. Install the Automatic Bus Transfer Assembly

  1.  Support the automatic bus transfer assembly from the bottom with your hand.
  2.  Align the assembly to the left chassis wall.
  3.  Slide the assembly into the server until the connector on the front of  the assembly plugs into the socket on the power backplane.
  4.  Install and tighten the four screws.


Step 5. Reinstall the 5-Volt Regulator Card

  1.  Slide the regulator card into the plastic card guides in the automatic  bus transfer assembly until the connector on the front of the  regulator card plugs into the socket on the power backplane.
  2.  Install and tighten the two regulator card screws.


Step 6. Reinstall the Power Supplies

 
  1.  Support the power supply -1- and slide it into the chassis.
  2.  Push the power supply handle -2- all the way in until the latches lock  in place.
  3.  Install and tighten the two power supply shipping screws -3-.
  4.  Install the remaining power supplies.


Step 8. Completing the Installation

  1.  Install the shuttle cam operating instruction label -4- that comes with  this option on the left side of the automatic bus transfer.
  2.  Reconnect all cables and connectors to the server.
  3.  If you are connecting two power sources to the Automatic Bus Transfer,  connect both power cords that come with this option to the Automatic  Bus Transfer. Discard the power cord that comes with the server.

    Important  If you are connecting only one power source to the Automatic  Bus Transfer, you must connect one power cord that comes with  this option to the right-hand power connector on the Automatic  Bus Transfer.

  4.  Set the power switch -5- on the power supplies to the On position.
  5.  Turn on the server power.
  6.  Verify that the AC Power and DC Power lights are on, indicating that  the power supplies are operating correctly.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.