Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Shuttle Assembly Removal (Netfinity 7000-M10 - Type 8680)



Shuttle Assembly Removal

Before you begin: Read 'Safety Information'.
 

To Remove the shuttle assembly, do the following:
  1.  Power-off the system.
  2.  Disconnect all power to the system.
  3.  Remove the top cover, see 'Removing the Top Cover'.
  4.  Disconnect all I/O board cables.
  5.  Disconnect all cables attached to the adapters installed on the I/O board.
  6.  Remove all adapters installed on the I/O board.
  7.  Remove the shuttle retainer clip -1-.
  8.  Remove the shuttle plate latch screw -2- and rotate  the shuttle plate latch away from the system.
     This will release the shuttle from the system.
  9.  While lifting up on the shuttle -3-, slide the shuttle out of the system.


More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.