Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Controls and Indicators (Netfinity 7000-M10 - Type 8680)



Controls and Indicators


The most commonly used controls and indicators on the front of the server appear in the following illustration.
 

1 - Next Button: Press this button to highlight an action to perform on a system monitoring message, then, press the Enter button to select the action.
You can select:


2 - Enter Button: Press this button to select an action to perform on system monitoring messages that appear on the information panel.


3 - Hard Disk Status Light: Each of the hot-swap drives has a Hard Disk Drive Status light.
When the amber light for a hard disk drive is lit continuously, the drive has failed.
When the light flashes slowly (one flash per second), the drive is being rebuilt.
When the light flashes rapidly (three flashes per second), the controller is identifying the drive.


4 - Hard Disk Activity Light: Each of the hot-swap drives has a Hard Disk Activity light.
When the green light for a hard disk drive is flashing, the drive is being accessed.


5 - CD-ROM Eject/Load Button: Press this button to eject or retract the CD-ROM tray so that you can insert or remove a CD.


6 - CD-ROM Drive In-Use Light: When this light is lit, the CD-ROM drive is being accessed.


7 - Diskette-Eject Button: Press this button to eject a diskette from the drive.


8 - Diskette Drive In-Use Light: When this light is lit, the diskette drive is being accessed.


9 - Power Control Button: Press this button to manually turn the server on or off.

  - Caution - The Power Control button on the front of the
server does not turn off the electrical current supplied to the server.
The server also might have more than one power cord.
To remove all electrical current from the server, ensure that all power cords are disconnected from the power source.

The server can be activated in several ways:



The server can be deactivated as follows:


1 - Reset Button: Press this button to reset the system and run the power-on self-test (POST).


11 - Information LED Panel: The lights on this panel give status information for the server. See 'Information LED Panel' for more information.


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.