Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Numeric Error Codes (SelectaDock II - III)



Numeric Error Codes

Symptom or Error    FRUs of the SelectaDock
     Sequence of Actions
  
10X, 11X 1. Adapter in slot (if used)
101: Interrupt failure. 2. Riser card
102: Timer failure. 3. Main card
103: Timer interrupt failure.
104: Protected mode failure.
105: Last 8042 command not accepted.
107: NMI test failure.
108: Timer bus test failure.
109: Low meg-chip select test.
195     Do the following steps:
(The computer was docked to the    a. Power-off and undock the system.
SelectaDock Docking system while    b. Power-on and shut down the system.
in hibernation mode.)    c. Power-off and dock the system.
 
1XX 1. See the Hardware Maintenance Manual of the computer.
      If the problem remains, go to Undetermined Problems
  
2XX 1. See the Hardware Maintenance Manual of the computer.
201: Memory data error. 2. Main card
202: Memory line error 00-15.
203: Memory line error 16-23.
205: Memory test failure on on-board memory.
221: ROM to RAM remap error.
3XX 1. See External Keyboard
  
6XX 1. Before changing any devices, run the diagnostic test.
      (See the How to Run the Diagnostics)
  2. FDD external attachment kit
  3. Diskette drive assembly
  4. Riser card
  
11XX, 12XX 1. Serial devices
  2. Communication cable
  3. Riser card
  
17XX 1. Hard disk drive (2.5-inch ThinkPad hard disk drive)
  2. Main card
  
24XX 1. Main card
  2. Riser card
  
860X 1. Mouse
  2. External keyboard
  3. Riser card
  
I9990301, I9990302 1. See the Hardware Maintenance Manual for the computer.
I9990305
Not shown above 1. See the Hardware Maintenance Manual for the computer.
  2. See Undetermined Problems.


More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.