Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Beep Symptoms (2523)



Beep Symptoms
Symptom / Error    FRU / Action
  
Continuous beep.    System Board
  
One beep and a blank, 1. LCD Assembly
unreadable, or flashing LCD. 2. System Board
  3. SIMM Card
  4. DC/DC Card
  
One beep, and the message "Boot 1. TPF (in Slot 1)
source (TPF) cannot be found" 2. System Board (TPF Controller)
  
One beep, and the message 1. TPF (in Slot 1)
"Unable to access boot source" 2. System Board (TPF Controller)
  
One long, two short beeps and 1. System Board
a blank or unreadable LCD. 2. LCD Assembly
  
One long beep followed by four 1. Connect an AC adapter
short beeps each time you press     or install a fully charged
the power on/off button.     battery.
      Computer cannot power-on due to
      low battery voltage.
  
One beep every second. 1. Connect AC
      adapter or install fully charged
      battery (allow computer to complete
      shutdown before changing the
      battery).
      Computer is shutting down due
      to low battery voltage.
  
Two short beeps. 1. POST error.
      See 'Symptom-to-FRU Index'
  
Three short beeps. 1. Move computer to a cooler
      environment.
      Battery or computer high
      temperature threshold has been
      exceeded.
  
Four short beeps every five seconds
and a blank LCD. 1. System Board
  2. SIMM Card
  3. Modem Card


More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.