|
|
|
| Symptom/Error | FRU/Action |
|---|---|
| 10X | 1. System Board |
| 110 | 1. Go to 'Memory Checkout' |
| 2. IC DRAM Card | |
| 3. System Board | |
| 111 | 1. Go to 'Memory Checkout' |
| 2. System Board | |
| 161 | 1. Go to 'Checking the Backup Battery' |
| 2. Backup Battery | |
| 3. System Board | |
| 163 | 1. Set Time and Date. |
| (Time and Date was not set.) | 2. System Board |
| 173 | 1. Select OK in the error screen, |
| (Configuration data were lost.) | then set time and date. |
| 2. Backup Battery | |
| 3. System Board | |
| 174 | 1. Check Device Configuration. |
| (Perform | 2. System Board |
| 'Checking the Installed Devices List' | 3. Diskette Drive Assembly |
| before changing any FRUs.) | 4. Hard Disk Drive Assembly |
| 184 | 1. Reset the POP in Easy-Setup. |
| (POP check sum error.) | |
| 190 | 1. Go to 'Checking the Battery Pack' |
| (A depleted battery pack was | |
| installed when the power was on.) | |
| 191XX | 1. System Board |
| 199XX | 1. System Board |
| 1XX | 1. System Board |
| 2XX | 1. Go to 'Memory Checkout' |
| 2. IC DRAM Card | |
| 3. System Board | |
| 301, 303, 304, 305, 3XX | 1. Go to 'Keyboard / Auxiliary Input Device Checkout' |
| 2. Keyboard | |
| 3. External Numeric Keypad | |
| 4. External Keyboard | |
| 5. Keyboard/Mouse Cable | |
| 6. System Board | |
| 601, 6XX | 1. Go to 'Diskette Drive Test' |
| 2. Diskette Drive Assembly | |
| 3. Diskette | |
| 4. System Board | |
| 602 | 1. Go to 'Diskette Drive Test' |
| (Diskette read error.) | 2. Diskette |
| 3. Diskette Drive Assembly | |
| 604 | 1. Go to 'Diskette Drive Test' |
| (Non-acceptable ID was read | 2. Diskette Drive Assembly |
| from the diskette drive.) | 3. System Board |
| 11XX | 1. Serial Device (First) |
| 2. Communication Cable | |
| 3. System Board | |
| 12XX | 1. Serial Device (Second) |
| 2. Communication Cable | |
| 3. System Board | |
| 17XX | 1. Hard Disk Drive |
| 2. System Board | |
| 24XX | 1. System Board |
| 808X | 1. PCMCIA Slot Assembly |
| 2. PCMCIA Device | |
| 3. System Board | |
| 860X | 1. External Mouse |
| (Pointing device error when | 2. External Keyboard |
| TrackPoint II or III is disabled.) | 3. System Board |
| 861X | 1. Reseat the keyboard TrackPoint |
| (Pointing device error when | II or III cable. |
| TrackPoint II or III is enabled.) | (See '1080 Keyboard Unit') |
| 2. Keyboard | |
| 3. External Mouse | |
| 4. System Board | |
| I9990301 | 1. Reseat the boot device. |
| I9990302 | 2. Check the startup sequence |
| I9990305 | for the correct boot device. |
| 3. Check that the operating system has no | |
| failures, and is installed correctly. | |
| I9990303 | 1. System Board |
| Other codes not listed above | 1. Go to 'Undetermined Problems' |
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.