|
|
|
MANUAIS DE
MOTHERBOARDS JBOND |
PCI600N/610N/620N
- Socket 370 (Intel PPGA)
- Intel 82443BX Chipset for PCI600N;
VIA VT82C693 Chipset for PCI610N;
Intel 82443ZX Chipset for PCI620N.
- SMC FDC37M602 Power Multi I/O Chip.
- Dimensions: 30.5cm x 17.7cm (12
inches x 7 inches) ATX form.
- Award PnP PCI flash BIOS.
- Three 168-pin DIMM sockets for PCI600N/610N;
Two 168-pin DIMM sockets for PCI620N.
- Two Enchance IDE sockets (up to four IDE
devices) support fast ATA-2, ATAPI, and Ultra DMA/33 functions.
- One Floppy socket supports two floppy
drivers with 360K, 720K, 1.22M, 1.44M, and 2.88M bytes.
- One AGP slot supports x1and x2 AGP card.
- Four PCI slots. (PCI spec. V2.1)
- Two ISA slots. (1 PCI/ISA shared slot)
- PS/2 keyboard and PS/2 mouse connectors on
board.
- Two Serial Port sockets.
- One Parallel Port socket supports SPP, EPP,
and ECP.
- Two USB Port connectors on board.
- One FIR (Fast IrDA) Port connector on board
(transfer rate up to 4MB/s).
- (New) LAN wake-up function.
- (New) Modem wake-up function to
switch system power on.
- (New) Automatic frequency reduction
in case of CPU overheating.
- Creative(TM) SB link ready function.
- (Optional) On board CMI8330 real 3D
HRTF Sound Chip.
- (Optional) System hardware health
monitor.
1. CPU Jumper Settings
* BIOS automatically detects CPU system
speed.
| Intel
Celeron |
JP2
PIN 1 |
JP2
PIN 2 |
JP2
PIN 3 |
JP2
PIN 4 |
JP1
PIN 1 |
| 233MHz |
ON |
NC |
ON |
NC |
1-2 |
| 266MHz |
ON |
ON |
NC |
ON |
1-2 |
| 300MHz |
ON |
NC |
NC |
ON |
1-2 |
| 333MHz |
ON |
ON |
NC |
NC |
1-2 |
| 366MHz |
ON |
NC |
NC |
NC |
1-2 |
| 400MHz |
NC |
ON |
ON |
ON |
1-2 |
| 433MHz |
NC |
NC |
ON |
ON |
1-2 |
| 466MHz |
NC |
ON |
ON |
NC |
1-2 |
| 500MHz |
NC |
NC |
ON |
NC |
1-2 |
| 533MHz |
NC |
ON |
NC |
ON |
1-2 |
Note:
- ON - jumper block short
- NC- jumper block open
2. Clear CMOS Data Jumper Settings
| Operating Mode |
CLS |
| Normal Operating
(default) |
Short 1-2 |
| Clear CMOS Data |
Short 2-3 while computer
powered OFF |
3. Support DIMM Module List
- Each DIMM socket supports 4M to128M bytes
(for 16Mbit technology) or 8M to256M bytes (for 64Mbit technology) DIMM
module.
- Vcc provides 3.3v
- Support SDRAM-II, SDRAM and EDO DIMM
modules.
4. (Optional) On board Sound Chip
Jumper Settings
| Operating
Mode |
SJP1 |
| Enable
(default) |
NC |
| Disable |
ON |
5. (Optional) MIC IN Select Jumper
Settings
| Operating
Mode |
SJP2 |
| Normal
Operating (default) |
NC |
| Special MIC
IN |
ON |
6. Support Year 2000 Compliance
- BIOS version 1.00 or later supports Year
2000 compliance.
7. Support LS-120 Zip Driver Boot
Function
8. Support SCSI/CD-ROM Function
9. Support INT 13 Expansion Mode
(control above 8.4 GB IDE Hard Disk)